IPCC SRES Scenarios


(About Demonstration)

The Intergovernmental Panel on Climate Change "Special Report on Emissions Scenarios" (SRES) explored pathways of future greenhouse gas emissions, derived from self-consistent sets of assumptions about energy use, population growth, economic development, and other factors. These considered a variety of possible "world-views", but explicitly exclude any global policy to reduce emissions to avoid climate change.

From SRES, six illustrative "marker" scenarios were selected for use in the climate projections of the IPCC Third Assessment Report. These are described below, followed by discussion of driving forces, climate impacts, and related topics.

Scenario descriptions

Global integration Regionalism
Economic emphasis A1B
Balanced energy
A2
A1FI
Fossil-fuel Intensive
A1T
high-Tech renewables
Environ-mental emphasis B1 B2

A1: Rapid convergent growth

The A1 scenarios all describe a future world of very rapid economic growth and global population that peaks in mid-century and declines thereafter, and the rapid introduction of new and more efficient technologies. Major underlying themes are convergence among regions, capacity building, and increased cultural and social interactions, with a substantial reduction in regional differences in per capita income.

The difference between the A1FI, A1B, A1T and scenarios is mainly in the source of energy used to drive this expanding economy.

  • A1FI: Fossil-fuel Intensive, coal, oil, and gas continue to dominate the energy supply for the forseeable future.
  • A1B: Balance between fossil fuels and other energy sources
  • A1T: emphasis on new Technology using renewable energy rather than fossil fuel.

    A2: Fragmented world

    The A2 scenario describes a very heterogeneous world. The underlying theme is self-reliance and preservation of local identities. Fertility patterns across regions converge very slowly, which results in continuously increasing global population. Economic development is primarily regionally oriented and per capita economic growth and technological change are more fragmented and slower than in other storylines.

    B1: Convergence with global environmental emphasis

    The B1 storyline and scenario family describes a convergent world with the same global population that peaks in mid-century and declines thereafter, as in the A1 storyline, but with rapid changes in economic structures toward a service and information economy, with reductions in material intensity, and the introduction of clean and resource-efficient technologies. The emphasis is on global solutions to economic, social, and environmental sustainability, including improved equity, but without additional climate initiatives.

    B2: Local sustainability

    The B2 storyline and scenario family describes a world in which the emphasis is on local solutions to economic, social, and environmental sustainability. It is a world with continuously increasing global population at a rate lower than A2, intermediate levels of economic development, and less rapid and more diverse technological change than in the B1 and A1 storylines. While the scenario is also oriented toward environmental protection and social equity, it focuses on local and regional levels.

    Discussion/Observations

    Driving Forces

    The regional emissions/socioeconomic data shown in JCM regional plots helps to reveal some of the driving forces behind the SRES scenarios. First, choose "SRES no-climate-policy scenarios" from the "mitigation" menu (top panel), then choose CO2 emissions, population, GDP or energy from the "what" and/or "per" menus on a regional plot, and compare scenarios with the SRES menu (top panel).

    For example, scenarios A1B, A1FI, A1T and B1 all have the same population, rising initially, but falling later this century, whilst for A2 and B2 the population, and consequent CO2 emissions, continue to rise in 2100. The implication is that global convergence of wealth in the A1/B1 group (look at the GDP data) helps to reduce population growth, and hence emissions.

    The difference between A1B, A1T and A1FI emissions, is therefore mainly related to energy use. The energy data here refers to secondary energy, such as electricity, also including energy from traditional biomass sources (fuelwood) which is higher in developing countries. So the ratio energy/emissions tells you about the carbon "efficiency" of energy production, whilst GDP/energy might indicate more about the economic "efficiency" of its application.

    See also:

  • Regional plot
  • About the regions
  • People module
  • Load-data module

    Effect on climate

    Considering the temperature rise by 2100, the "hottest" scenario is A1FI, followed by A2, A1B, B2, A1T, and B1 is the "coolest". However, in the A1B and A1T fossil CO2 emissions are falling by 2100, whereas in A2 and B2 they are still rising, implying that climate impacts would be greater during the following century.
  • Temperature plot

    The SRES also specifies other factors which influence climate change. For example, in scenarios A1FI, B1 and B2, CO2 emissions from land-use change drop below zero (implying net reforestation). (You can see this on the carbon cycle plot: drag the y-axis near the origin, to move it up)

    Scenario A2 also has relatively higher sulphate emissions than A1FI (this causes local cooling). In scenario B1, the emissions of methane and HFCs are also much lower. See also:

  • Cause-effect flowchart
  • Carbon Cycle, Other gases, Radiative forcing

    You can check the correspondence of the predictions from this model, with data published in IPCC-TAR-WG1 SRES appendix, shown as small circles superimposed on the plots (expert level).

  • See Correspondence with IPCC data

    The 100-year time-frame of the SRES scenarios is too short to give a meaningful view of the effect on some slower climate processes, especially sea-level rise. In this model the scenarios are extended simply by assuming constant emissions after 2100. This is for transparency and is not intended as a prediction.

  • See Timescales of response

    Comparison with Mitigation

    SRES scenarios may be used as baselines for comparison with stabilisation scenarios in order to calculate the required mitigation effort (this is known as the "post-SRES" process).

    Also, the SRES projections for emissions other greenhouse gases may be combined with CO2 stabilisation scenarios (as in IPCC-TAR Synthesis report Q6).

  • Emissions of other greenhouse gases
  • Distribution of Emissions
  • Comparison with Kyoto protocol
  • Mitigation and Post-SRES scenarios

    Note, for this reason, the SRES menu remains available, even when the CO2 emissions are determined by other mitigation options.


    SRES Demonstration

    The demo wizard cycles through the six SRES scenarios, showing in turn:

  • CO2 emissions (regional and global)
  • Other gases / F-gases
  • Radiative forcing / Temperature,
  • Regional temperature / Sea-level
  • Population / Per-capita emissions
  • GDP percapita / Energy percapita

    Click the button to stop the demo and explore for yourself.